Initial Use Of Parent Unit With Battery; Initial Use Of Parent Unit With Mains; Operating The Parent Unit; Infrared Night Vision - Inanny NM288 Manuel D'utilisation

7.2 Initial use of parent unit with battery

1. Remove the assembly clip.
2. Open the cover on the rear of the parent unit by sliding it downwards.
3. Insert the battery included in delivery as shown.
4. Slide the cover on the rear of the parent unit back up again, until you can
hear and feel it slot into place.
5. Snap the assembly clip into place once more.
6. Press the ON/OFF button
already switched on, the transmission image from the camera will
automatically appear on the screen. If the camera is still switched off, an
acoustic signal is emitted and the following symbol appears on the monitor:
.
7.3 Initial use of parent unit with mains part plug
1. Connect the small end of the "Monitor" parent mains part plug with the
parent unit.
2. Connect the other end of the mains part plug to the socket.
3. The parent unit switches on automatically. Press the ON/OFF button to switch
off the unit. If the parent unit and camera are already switched on, the
transmission image from the camera will automatically appear on the screen
of the parent unit.

8. Operating the parent unit

8.1 Infrared night vision

In order to ensure that clear transmission images can be seen on the screen
even when it is dark, the Video Baby Monitor automatically activates the
infrared night vision in the dark. When the infrared night vision is active, a moon
symbol ( ) is shown on the screen.

8.2 Setting the volume

The parent unit has 5 volume levels.
To adjust the volume, press the (

8.3 Setting the brightness

The parent unit has 5 brightness levels.
To adjust the brightness, press the (

8.4 Intercom function

The parent unit has an intercom function.
To activate the intercom function, hold down the ( ) button on the parent unit
and speak into the unit. The words you have spoken can now be heard on the
camera. To deactivate the intercom function, release the ( ) button again.
to switch on the parent unit. If the camera is
) button or the (
) button or the (
8
) button.
) button.