Important Safeguards - Alpina SF-7656 Mode D'emploi

When using electrical appliances, basic safety precautions should be followed:
1. Read all instructions carefully.
2. Make sure the power supply corresponds to one on the rating label.
3. To avoid electrical shock, do not immerse electrical parts in water or other liquid.
4. Do not allow children to operate or play with the appliance.
5. Unplug from outlet when not in use, or before putting on/taking off parts.
6. Do not use if power cord/plug is damaged, should be replace by qualified person to avoid potential hazard.
7. If damaged or malfunction occurs, refer to an authorized service center only.
8. Do not place on or near hot surfaces.
9. Never pull the appliance by the power cord.
10. Do not use the appliance for other than intended household use.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless they have been given supervision or instruction by a
person who is responsible for their safety concerning the use of the appliance. Children should be supervised
to ensure that they do not play with the appliance.
Parts Description
1. Side panel
2. Net
3. Heating Plate
4. Power setting switch
5. Power light
6. Thermostat control
7. Support leg
Save these instructions:
1. Please read the instruction manual carefully before using the heater. Any misuse operation can cause of
fire, short circuit and personal injuries.
2. Using power cord extension is not allowed to avoid fire caused by overheating of the extension part.
3. In order to prevent short circuit, fire or damages to the appliance, never insert any article into the heater
or block the cooling net and never cover the heater during use to avoid risk of fire.
4. Since the heater can generate heat, don not touch the hot surface. Grab the plastic handle at the rear to
move the heater when necessary.
5. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
6. Standing Installation: Take the heater out from
the package and place it upside down in soft
surface. Place the support leg at the side of the
panel ( 1 leg for 1 panel) then place the heater
upright and put it into use, you may refer to
below figure.

IMPORTANT SAFEGUARDS

ENGLISH