Cleaning & Maintenance - Alpina SF-7656 Mode D'emploi

Instructions for use
1. Make sure the power supply corresponds to one's on the rating label with the thermostat control
switch in the low position and the power setting switches in the "0" position.
2. Insert the plug into the socket (requirements for socket and power cord: AC 220-240V, 50Hz, ≥10A).The
heater must not be located below a fixed socket.
3. Switch the heater to one of the following power settings: the power switch lights up when
activated.
a. Push switch one (I) for 300watts
b. Push switch two (II) for 600watts
4. Room temperature can be adjusted using the thermostat. Simply turn the thermostat knob clockwise to
increase the heat and anti-clockwise to decrease the temperature until you reach the desired
temperature.
5. Once you have finish using the heater, turn the power switches off and the thermostat control to low
position and unplug from the mains supply.
Circuit Diagram
Warning:
This appliance is equipped with a grounded, Type G, 2-pin power supply cord. This is a safety feature. Do not
attempt to defeat the safety purpose of this plug.
CLEANING & MAINTENANCE
1. Always make sure the appliance is unplugged from electrical outlet & sufficiently cool before
cleaning.
2. The dust stain in the body of the heater can be scraped softly or sucked away with the dust
collector.
3. Do not damage the components of the heater.
4. When the unit is not to be use for a longer time, clean it and seal in a plastic bag then store in a
dry place, packed it according to its packing method.