Important Safeguards - Alpina SF-9360 BS Mode D'emploi

Dear Customer,
Thank you for choosing this ALPINA home appliance. Your Alpina appliance comes with a 2 year warranty and will provide years of
service if looked after properly. The ALPINA name brings you Quality, Reliability and Dependability. We hope you will c
make ALPINA your first choice in home appliances
When using electrical appliances, basic safety precautions should be followed:
1. Read all instructions carefully.
2. Make sure the power supply corresponds to one on the ra ng label.
3. To avoid electrical shock, do not immerse electrical parts in water or other liquid.
4. Do not allow children to operate or play with the appliance.
5. Unplug from outlet when not in use, or before pu ing on/taking off parts.
6. Do not use with damaged electrical cord or plug.
7. If damaged or malfunction occurs, refer to an authorized service center only.
8. Do not place on or near hot surfaces.
9. Never pull the appliance by the power cord.
10. Do not use the appliance for other than intended household use.
Caution
Use the heater on a firmly mounted ver cal pole (flat surface) or roof mounted. Where floor mounted base should be in contact
with the floor. (Should the heater be tilted or fall over, the auto cut off switch will ac vate.)
1. The unit must be correctly installed according to the instruc ons. Make sure the heater is fixed at a height of at least 1.8m
above the floor.
2. When assembling, keep clear from any board or flammable material.
3. Do not use the heater near bath tubs, wash areas or swimming pools.
4. Do not place on or near inflammable things such as gas, petrol, paint, curtains etc.
Do not put cover on the grill of the heater head, during opera on.
5.
6. Do not leave unattended if the heater is switched on.
7. The unit must be placed at least 180cm from the floor level and at least 60cm away from the parasol cloth or roof.
8. The unit is at high temperature during operation. It remains hot for a period of time after power off. Potential danger would
occur when touching it during this period.
9. One or two dark points may exist on the surface of the heating elements during the first few minutes after it is turned on. This is
quite normal, and will not affect the performance of the unit.
10. The unit must be securely grounded during operation.
11. A lt switch is fitted inside the unit for safety purpose.
INSTRUCTION
Unpack the electric parasol heater and make sure that all items are complete.
Step 1: Place the Heater Mounting Part A on a Pole with diameter between 25mm-48mm.
Step 2: Slip the Moun ng Part B and fit it to the Moun ng Part A from the bo om up.
Step 3: Turn the Fixa on Screw until the Mounting Part A is fixed on the pole & firmly ghten
Step 4: To operate the heater, please ensure that all three arms are fully erect and secured. To do this, lift each arm by holding the
small end handle and lift until a 'click' is heard and the arm is horizontal and fully locked.
Step 5: When you have finished using the heater, allow each of the arms to cool down sufficiently before touching. Beware as these
will still be hot for a while after operation. Then, whilst holding the arm with one hand, depress the small silver button as shown in
the diagram with the other hand and gently lower each arm to a vertical posi on. DO NOT ATTEMPT TO FORCE THE ARMS DOWN
WITHOUT DEPRESSING THE SILVER BUTTON AS THIS COULD RESULT IN SERIOUS DAMAGE.
.

IMPORTANT SAFEGUARDS

2
ENGLISH
e to