Electrical Connection - AEG DD9996-B Mode D'emploi Et Installation

9
INSTALLATION
RECIRCULATION VERSION AIREOUTLET
To install the hood in recycling version, the
optional charcoal filter kit must be purchased.
• Remove the chimney angle bracket.
• Screw the filter cover onto the air outlet,
using four screws 12c (2.9 x 12.5).
• Fix the air outlet grid 8 on the recircula-
tion air outlet using the 2 screws 12d (2,9
x 9,5) provided.

ELECTRICAL CONNECTION

• Connect the hood to the mains supply.
• Open the upper panel by pressing the A-key
(See Part "USE" ) for at least 2 seconds.
• Remove the metal filters (See Part "MAINTE-
NANCE") and make sure that the connector
piece of the supply cable is correctly inside the
hood socket.
FLUE ASSEMBLy
Upper exhaust Chimney
• Slightly widen the two sides of the upper
chimney and hook them behind the brack-
ets 7.2.1, making sure that they are well
seated.
• Secure the sides to the brackets using the 4
screws 12c (2,9 x 9,5) supplied.
Lower exhaust Chimney
• Slightly widen the two sides of the chimney
and hook them between the upper chimney
and the wall, making sure that they are
well seated.
• Fix the lower part laterally to the hood
body using the 2 screws 12c (2,9 x 9,5)
supplied.
���
�
���
��
�����
���
�
���
���
���