Safety Considerations; Dimensions And Arrangements - Dustcontrol TPR 50 30kW Notice Originale

Safety Considerations

Read all instructions before the machine/installation
is commissioning.
The equipment must be installed and maintained pro-
perly by qualifi ed personnel who have study this user
instruction. Dustcontrol does not take responsibility
for defective installation or maintenance.
Warning! When using electric machines, basic sa-
fety precautions should always be followed to reduce
the risk of fi re, electric shock and personal injury,
including the following:
1. Work area environment
Keep the area around the central unit clean.
Do not store or work with fl ammable liquids or
gases near the machine.
2. Overload
If there is an alarm signal it should be care-
fully checked out to see that the machine is
un damaged. If there are any damaged parts
these should be repaired by a Dustcontrol
authorized service centre. Always follow the
regulations pertinent to the material you are
working with. Do not use the machine for pur-
poses that it is not intended for.
3. Bodily injuries Warning - High negative pres-
sure
Do not start the pump without having it con-
nected to the duct work. Do not adjust the
vacuum relief valve while the pump is ope-

Dimensions and Arrangements

rating. Never let the suction come in contact
with parts of the body, for example a hand.
The pump generates a high negative pressure,
severe injury may result.
Warning - Very hot exhaust air
Exhaust air can be very hot, up to 150
4. Electricity
A separate lockable disconnect must be instal-
led where it is readily accessible to the pump.
Do not repair the electric components yourself,
get somebody qualifi ed. Faults may cause
injury. The electrical connections may only be
performed by a certifi ed electrician. See also
under section 7, 'Warning'.
5. Important measure
The electrical disconnect should be locked in
the "off" position before demounting the safety
panels or ducting.
6. Checking for damage
Check the machine regularly for damage. If
there are any damaged parts these should be
repaired by a Dustcontrol authorized service
centre.
7. Warning
Use only accessories and replaceable parts
which are available in Dustcontrol catalogue.
When using non-genuine parts, especially
fi lters and plastic sacks, dust leaks could occur
which may be hazardous to health.
TPR 35, TPR 40, TPR 43, TPR 47, TPR 50
TPR 50, 30 kW - 13
O C.
Part No 9050-A