Publicité
Les langues disponibles
Les langues disponibles
The product does not work properly (2/2)
Abnormal noise.
The unit leaks.
The indicated
hygrometry rate
does not change.
The information
(temperature and
humidity level) seem
to be incorrect.
Resonant in water tank
when water level is too low.
The unit is on a unstable
surface
The tank is not filled in the
right way.
The tank cap is not well
closed.
Seal tank cap fell during
filling.
The room is too big.
The sensor is dirty.
The sensors respectively
have a margin of error.
Fill water into water tank.
Move the unit to a stable flat
surface.
Turn over the tank, unscrew the
cover, and fill in with water
(see Tank filling section).
Make sure the tank Cork is rightly
tighten.
Replace the seal in the cap. Take
the opportunity to clean with soap
and water!
Compare with another hygrometer
in order to check if the device's
hygrometer is defective.
Clean the hygrometer. Blow into
the sensor to dislodge eventual
dust particles (locate the sensor on
the scheme "
").
⑦
Thermometer: ±2°C
Hygrometer: ±5%
15
Publicité
