Maintenance And Service; Maintenance And Cleaning - Bosch GWS 24-300 Professional Notice Originale

OBJ_BUCH-280-003.book Page 27 Thursday, November 12, 2009 1:21 PM
Cutting Stone (see figure A)
For cutting stone, always work with the cut-
ting guide with dust extraction protection
guard 17.
The machine may be used only for dry cut-
ting/grinding.
For cutting stone, it is best to use a diamond
cutting disc. As a safety measure against jam-
ming, the cutting guide with dust extraction pro-
tection guard 17 must be used.
Operate the machine only with dust extraction
and additionally wear a dust protection mask.
The vacuum cleaner must be approved for the
extraction of masonry dust. Bosch provides suit-
able vacuum cleaners.
For cutting expecially hard material, e. g., con-
crete with high pebble content, the diamond
cutting disc can overheat and become damaged
as a result. This is clearly indicated by circular
sparking, rotating with the diamond cutting
disc.
Bosch Power Tools
The machine must In this case, interrupt the cutting process and al-
always work in an low the diamond cutting disc to cool by running
up-grinding mo- the machine for a short time at maximum speed
tion. Otherwise, with no load.
the danger exists
Noticeable decreasing work progress and circu-
of it being pushed
lar sparking are indications of a diamond cutting
uncontrolled out
disc that has become dull. Briefly cutting into
of the cut.
abrasive material (e. g. lime-sand brick) can re-
When cutting pro- sharpen the disc again.
files and square
Information on Structures
bar, it is best to
start at the small Slots in structural walls are subject to the
est cross section. Standard DIN 1053 Part 1, or country-specific
regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architect or
the construction supervisor.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
Switch on the ma-
tion slots frequently and install a residual
chine and place
current device (RCD). When working metals,
the front part of
conductive dust can settle in the interior of
the cutting guide
the power tool. The total insulation of the
on the workpiece.
power tool can be impaired.
Slide the machine
Please store and handle the accessory(-ies)
with moderate
carefully.
feed, adapted to
the material to be
If the machine should fail despite the care taken
worked.
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
English | 27
3 609 929 B90 | (12.11.09)