Abicor Binzel WH Mode D'emploi page 47

WH / WHPP
NOTICE
• Do not change the hand lever position during the change procedure! This will result in
malfunctions. The open knife will cause the pre-tensioned welding wire to expand and to
become cut off when actuated next. These wire pieces will block the locking mechanism
and inevitably lead to failures of the entire system!
1 Insert the hand lever through the sealing lips of the clamp clip into the bore.
2 Move the hand lever forwards in the direction of the torch neck past the pressure point to the
stop and take out the torch neck.
3 Insert the torch neck into the changeable body up to the stop.
4 Push the hand lever toward the rear up to the stop and take it out, after locking it.
6.13 Automatic torch neck change
The ATS rotor torch change system is a peripheral device that performs the torch neck change
during the fully automatic welding process. Request order documentation on this or consult
special documents for the exact procedure.
7 Operation
DANGER
Shortness of breath and poisoning caused by inhaling phosgene gas
During the welding of work-pieces that have been degreased with chlorine-containing
solvents phosgene gas is formed.
• Do not inhale fumes and vapors.
• Ensure sufficient supply of fresh air.
• Rinse work-pieces with clear water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding work spraying sparks, glowing work-pieces or hot slag can produce flames.
• Check work area for seats of fire.
• Make suitable fire extinguishing materials available at the workplace.
• Allow work-pieces to cool down after welding.
• Prior to performing welding work, fasten the ground clamp properly to the work-piece or
the welding table.
BAL.0014 • 2019-01-16
7 Operation
EN - 19