Mounting The Bar And Chain - IKRA PKS 4235 Manuel D'utilisation

3. DESCRIPTION OF PARTS OF THE MACHINE
DESCRIPTION (fig.1)
1) Rear hand-guard
2) Chain catcher
3) Chain
4) Chain guide bar
5) Bar cover
6) Spike
7) Front hand guard / Chain safety brake lever
8) Front handle
9) Throttle trigger look-out
10) Throttle trigger
11) Rear handle
12) Engine stop switch (STOP)
14) Choke/throttle advance knob
15) Carburettor setscrew
16) Fuel tank cap
17) Chain oil tank cap
18) Starter cord handle
19) Bar locking nut
20) Chain tension screw
21) Chain tension tooth
22) Starter
23) Top cover
24) Exhaust silencer
25) Chain cover
26) Top cover screw
27) Fuel primer

4. MOUNTING THE BAR AND CHAIN

WARNING! DO NOT START THE CHAIN-
SAW BEFORE YOU HAVE MOUNTED AND
ADJUSTED THE BAR AND CHAIN.
WEAR SAFETY GLOVES WHEN PER
FORMING THIS OPERATION. THE CUT-
TING TEETH (OF THE CHAIN) CAN CAUSE
WOUNDS
1) Open the box containing the chainsaw and extract
the disassembled parts and accessories as shown in
Fig.2. In the box you will find:
GB | Operating Instructions
Part 1 - Chainsaw body
Part 2 - Chain guide bar
Part 3 - Chain
Part 4 - Combination spanner
Part 5 - Chain adjustment screwdriver
Part 6 - Chain sharpening file
Part 7 - Instruction manual
2) Position the Chainsaw body as in Fig. 3 and make
sure that the (chain) safety brake is not engaged (ar-
row Fig. 3).
3) Unscrew the nuts (Fig. 4 part.1) and remove the
brake cover.
4) Rotate the chain tensioning screw anticlockwise (un-
screw direction) (Fig. 5 part.1) so that the chain ten-
sioning tooth retreats (Fig. 5 part.2).
16