Use; Electricity Cable; Air Gun - Ferm CRM1049 Traduction De La Notice Originale

• I t can be more difficult to start-up the motor
during conditions of temperatures below 0°C.

3. uSE

For household use only
Connecting the device to an outlet.
Fig A
• O pen the black cover and take out the
electricity cable (4), air hose (5) and required
accessories from the storage compartment (1).
• M ake sure the ON/OFF switch (3) is in the
position 'O' (switch off).
• C onnect the electricity cable (4) to an outlet.
Before using he machine, make sure that the
mains voltage complies with the specifications on
the rating plate. Long supply cables, extensions,
cable reels etc. cause a drop in voltage and can
impede motor start up.
The appliance vibrates during operation.
During operation, always put it down
backwards on its rubber feet.
On/Off switch (3)
Fig A
• M ove the ON/OFF switch (3) into the position
'I' to switch the appliance on.
• M ove the ON/OFF switch (3) into the position
'O' to switch the appliance off.
The appliance is not designed for
continuous operation. To prevent the
motor from overheating, the appliance
may only be used as follows: Within a
period of 10 minutes, the appliance may
only be operated for 15% of the period
so 1,5 minute. During the rest of the
period (8.5 minutes) the appliance needs
to cool down again.
6
Connecting the air gun (6)
Fig A + B
• I nsert the connector (6e) of the air gun (6) into
the quick coupler (5a) on the air hose. When
pushing, the connector clicks into place to
secure the air gun.
disconnecting the air gun (6)
Fig A + B
• P ull back the sleeve on the quick coupler and
remove the tool.
When releasing the quick coupler, be
sure to hold the coupling to protect
yourself from injury from the rebounding
hose.
using the air gun as blow-out pistol
Fig A + B + C
This way the air gun can be used for blowing air
for several cleaning purposes and to clear hard-
to-reach area's. The trigger (6f) on the gun allows
exact dosing of the air volume.
• U nscrew the hose (6c) from the air gun (6)
• R eplace it by the extension nozzle (7).
using the air gun for inflating car tires
Fig A + B
This way the air gun can be used for inflating tires,
inflatable beds etc.
• I n case the hose (6c) is not assembled,
connect it to the air gun (6) by screwing.
• C onnect the air coupler (6d) directly to a air
valve of the object to be inflated. To connect:
press the clamp on the hose and push it onto
the valve of the object.
• F irst check the pressure of the object:
• R ead the pressure on the gauge (6b):
• P ressure too high: press the button on the
left side to release air (6a).
• P ressure too low: press the trigger to fill the
object till required pressure (6f).
• C heck pressure by releasing the trigger and
read the pressure gauge.
• D isconnect the tyre inflating gun.