BQS BTW123 Notice D'instruction page 13

5. INSTALLATION OF CHILD SEAT. GROUP 1.
WARNING
1. Check that the height of the harness straps is appropriate. The
child's shoulders should be just below the harness slots (5.1). In the
highest position (Pos.3), the harness must pass through the seat
belt guide area (5.2).
2. Slacken the harness straps pulling the chest portion of the straps
while pressing the harness adjustment button (5.3).
3. Open the buckle (to facilitate placing the child in the seat you can
place the harness straps on the armrest (5.4) and place the child in
the seat. Closet he buckle as indicated by fig. 5.5 and 5.6 until you
hear a "Click".
4. Stretch the harness adjustment tape to give the harness the
correct tension (5.7). Remember that to ensure the child's safety
the harnesses must be securely fastened.
6. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD. GROUP 1.
WARNING
1. To change the position of the harness you must remove the chest
straps of the harness connector from the back of the seat (6.1 &
6.2).
2. Stretch the chest tapes round the front of the seat until all the tape
is out (6.3).
3. Reposition the harness depending on the child's height. Remember
that the correct position is defined in fig. 5.2. Do not forget to also
change the height of the shoulder protectors (6.4).
4. Reattach the chest tapes to the harness connector (6.5 & 6.6).
5. ATTENTION. When using the highest harness position you must
remove the reducing gear and move the position of the buckle.
Remove the metal plate located on the bottom of the seat and
reposition the buckle assembly (6.7, 6.8, 6.9 & 6.10).
24
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
BTW 123
7. HARNESS REMOVAL. GROUP 2 & 3.
Use Group 2 & 3 only from approx. 4 to 12
WARNING
years of age (15-36 kg)
1. To change the position of the harness you must remove the chest
straps of the harness connector from the back of the seat (7.1 &
7.2). Remember to change the position of the shoulder pads.
2. Stretch the chest tapes round the front of the seat until all the tape
is out (7.3 & 7.4).
3. Stretch the tapes below the elevator (7.5 & 7.6).
4. Remove the buckle anchors located in the elevator as shown in
image (7.7).
8. INSTALLING CHILD SEAT. GROUP 2 & 3.
Use Group 2 & 3 only from approx. 4 to 12
WARNING
years of age (15-36 kg)
Make sure you have installed the ISOCLICK anchors before installing
the chair as indicated in Group 2 and 3.
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps as shown in Chapter 7.
1. Place the child seat on the vehicle seat pressing against the back
of the vehicle seat (8.1).
2. Place the child in the child restraint seat with height adjuster
child's shoulders (8.2).
3. Fasten the belt, ensuring that the lap belt goes through the guide
under both armrests and that the diagonal shoulder belt passes
through I height adjuster on the childrens shoulder and under the
armrest that is next to the vehicle anchor point. Fasten the seat
belt into the vehicle´s buckle until it "clicks", making sure the child
seat is properly installed (8.3, 8.4, 8.5 y 8.6).
4. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle seat
belt or prevent the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as described in the
instructions.
EN
I at the
www.babyqs.com
25