Set Up; Dmx Mode - Evolite EvoScan 90 Mode D'emploi

 Set up
The device has two operation modes. It can be operated in Stand Alone or in DMX controlled
Main Menu
The control board offer several features :you can simple set the starting address, run the pre-programmed program or make
a reset the main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by pressing Up or
Down .Press the Enter-button in order to select the desired menu. You can change the selection by pressing Up or Down,
Confirm every selection by pressing the Enter-button. You can leave every mode by pressing the Mode/Esc-button .The
functions provided are described in the following setting.
Mode
DMX address
Channel mode
X reverse
Y reverse
XY exchange
XY encoder
Screen mode
Version
Reset
o Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-device
o DMX Mode
DMX mode is selected in the main menu (make sure fixture is not in Auto Mode).
You can control the fixtures individually via your DMX-controller
Just select the fixture address, knowing that this address will be the start address. ( 1
The EvoScan 90 provides 2 DMX modes:
1- 15 channels DMX mode
2- 19 channels DMX mode.
These 2 modes are selectable in the main menu by the Channel modes function.
Note. If 2 EvoScan 90 are addressed with same DMX value, they will move exactly the same way.
EvoScan 90 Manual Ver. 1
DMX
Auto 1 /Auto 2 Auto 3 /Auto 4
XY effect 1/ XY effect 2 / XY effect 3 /XY effect 4
Random effect /Sound
Setting DMX address from 001-512
Select 15 or 19 DMX channel
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON display no light after 30 seconds
OFF display light always on
Software version/DMX channel/run time/Total use time
ON/OFF
st
DMX channel).
Page 15