Panasonic AJ-PCD20 Mode D'emploi page 10

Installation
(continue)
5
(To be connected by IEEE1394b)
Connect the P2 drive to the personal
computer with a IEEE1394b cable.
USB 2.0 IEEE 1394b
IEEE1394b connector
<Notes>
No IEEE1394b cable is supplied with the
P2 drive in
commercially available IEEE1394b cable.
Before proceeding
connect the unit which uses
a 6-pin type IEEE 1394
connector, carefully check
the shape
IEEE1394b cable and the
connectors on IEEE1394b
cable. Connecting a connector upside
down may damage the parts inside the
unit and cause malfunctioning.
Do not apply force when connecting
IEEE1394b cable to IEEE1394b connector
as this may damage the connector.
E-9
DC IN 16V
DC IN 12V
the package. Use
to
of the
6-pin type
6
Verify that the personal computer recognises
the P2 drive.
<Notes>
In Windows XP, some card slots of the P2
drive may be assigned drive names that
have already been assigned to existing
networks. Reassign network drive names
if your personal computer does not display
all five card slots.
In Windows, to remove a USB cable or an
IEEE1394b cable, select "Safely Remove
Hardware" in the "Task Tray" and stop the
"Panasonic P2 Series USB/SBP2 Device"
before removing the cable.
a
On an Apple Macintosh, to remove an
IEEE1394b cable, drag the icon of the P2
card to "Trash" and then confirm that the
P2 card icon disappears before removing
the cable.