Maintenance; Maintenance Schedule - Husqvarna 525LS Mark II Manuel D'utilisation

Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
1560 - 002 - 22.06.2021

Maintenance

Read and understand the
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.

Maintenance schedule

WARNING:
and servicing given in this operator's
manual. For maintenance or servicing that is
not given in this operator's manual, speak to
your servicing dealer.
Clean the trimmer head
Only do the maintenance
15