Operation - Husqvarna 525LS Mark II Manuel D'utilisation

8. To disassemble, do the procedure in the opposite
sequence.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles, such as stones, branches
and ditches.
• Do an overhaul of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, the trimmer guard and the
trimmer head are correctly attached and not
damaged. Replace the trimmer head and cutting
attachment guard if they have been hit or if they
have cracks.
• Examine the support flange for cracks. Replace the
support flange if it is damaged.
• Make sure that the locknut can not be removed by
hand. The locknut must have a locking force of
minimum 1.5Nm. Make sure that the tightening
torque is between 35-50 Nm.
1560 - 002 - 22.06.2021

Operation

WARNING:
without a guard or a guard that is defective.
Connectivity
This product is prepared for connectivity and has a
location for installation of a Husqvarna Connectivity
Device. When the Husqvarna connectivity device is
installed, the product has
technology and can use Husqvarna Fleet Services
connect to mobile devices. This enables more functions.
To install the Husqvarna connectivity device
Do the steps that follow to install the Husqvarna
connectivity device. For more information about the
Husqvarna connectivity device, refer to
www.husqvarna.com.
1. Remove the screw and open the plastic cover.
2. Remove the connector.
Do not use the product
®
Bluetooth
wireless
™
to
11