Battery Pack; Capacity Display - Festool AGC 18 Notice D'utilisation D'origine

On/off switch [1-5] is locked and the power tool
is switched on.
Only position the tool on the material once
it has reached operating speed.
Setting the speed
The speed can be adapted in six settings de­
pending on the workpiece requirements.
► Set the speed regulator [1-4] to the re­
quired setting.
Switching off [2B]
► Lift the power tool from the processed ma­
terial.
► Press the rear part of the on/off
switch [1-5].
Lock is released and the power tool is switched
off.
WARNING
Risk of injury from kickback, ejected parts
► Before setting down the power tool, wait
until the rotating sanding tool has come to
a complete stop.
► Set the power tool down on the support
points [1-11].
2A
8

Battery pack

► Inserting the battery pack [3A]
► Removing the battery pack [3B]
BP 18
3A
2B
1
2
1
3B
8.1

Capacity display

The capacity display [1-10] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-9] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery pack
and charger can be found in the corre­
sponding operating manual.
9 Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
9.1 Fitting the auxiliary handle [1-6]
Always use the auxiliary handle to ensure
a safe working posture that prevents you
from tiring.
The special "VIBRASTOP" design of the auxiliary
handle helps to reduce vibrations.
► Screw in the auxiliary handle [1-6] on the
side of the thread [1-3] according to the
working method.
9.2 Fitting the sanding tool [4]
CAUTION
Risk of injury from hot and sharp tool
► Do not use any vibrating, blunt or defective
sanding tools.
► Do not use sanding tools that have been
exposed to extreme humidity, moisture or
high temperatures prior to installation.
► Wear protective gloves.
English
70‑100%
40‑70%
15‑40%
< 15%
*
13