Operating Instructions - Danby Silhouette Professional DAR055D1BSSPRO Manuel Du Propriétaire

Use the appliance between 41-90°F (5-32°C) ambient temperature. If the ambient temperature is higher than
or lower than this temperature it will cause temperature fluctuation in the cabinet.
CONTROL PANEL
INSTRUCTIONS
Indicator light illuminates to signify the cooling mode
is currently in operation.
Control the interior light ON/OFF.
To turn appliance on/off (press and hold this button
for approximately 3 seconds).
Used to raise(warm) the temperature by 1°
increments.
Used to lower (cool) the temperature by 1°
increments.
(°C / °F) Adjacent indicator light denotes which scale of
temperature is displayed.
SETTING THE TEMPERATURE
CONTROLS
When you plug in your refrigerator for the first time the
temperature will automatically be set to 41 °F (5°C) and
will be displayed in the Fahrenheit scale (°F). (Default
setting)
• The temperature range can be set as low as 36 °F (2°C)
or as high as 50°F (10°C) to suit your specific storage
requirements. Each depression of the
button will allow you adjust the temperature in 1°
increments within the aforementioned range.
• To switch the display between the Fahrenheit (°F) and
Celsius (°C) scale, depress the
simultaneously for approximately 3-5 seconds.
OPERATING INSTRUCTIONS
or
and
FUNCTIONS
Temperature Memory Function
• If power is lost the set temperature will be saved by the
unit. Once the power is back on the unit will return to the
same set temperature.
Door Ajar Function
• If door is not fully closed, there will be a warning alarm
after 5 minutes.
Temperature Alarm Function
• If inner temperature is higher than 73°F (23°C), "HI" is
shown in display panel and the alarm will sound after
one hour. It is to inform you that the inner temperature is
too high, please check the reason.
• If inner temperature is lower than 34°F (1°C), "LO"
is shown in display panel and the alarm will sound and
the malfunction indicator light will appear at the same
time.
SHELVES
IMPORTANT!
Do not cover the gap on the glass shelves with alu-
minum foil or any other material that will prevent ade-
quate air circulation within the cabinet.
When removing any of these shelves out of the rail com-
partment, you must first disassemble and remove the
plastic posts then remove the Lock screws that hold each
post in place.(Fig A)
To re-install, ensure the shelf is resting securely on the
support brackets and push shelf inward until it locks into
place.
Gaps
6
Plastic
Lock
Posts
Screws
Fig A.