Positioning The Logs; Fitting The Glass Panel; Mounting The Front Panel; Remote Control - Dru Avanto Concerto Instructions D'installation Et Mode D'emploi

Positioning the logs

Position the logs as follows:
• Lay the large log against the back wall, on the log
supports.
• Fill the burner with vermiculite (this is in the plastic bag
with the log set).
• Spread it evenly over the burner tray and the
surrounding tray.
• Sprinkle the bag of brown embers, black and yellow chips
on the top of the vermiculiet on the burner to create a
glowing effect on the burner bed.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.
• Now lay the rest of the logs in place as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs
touch pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.

Fitting the glass panel

Once the logs are in place, the glass can be replaced in
the brackets nges and tightened with the two socket-head
bolts. In the event of damage or breakage, the glass
should be replaced immediately.
Mounting the front panel (fig. 9)
The coloured or stainless steel frame (A) is packed
separately from the basic set.The frame is fitted to the
front panel (B) using the 8 bolts supplied (C). Make sure
that the tall edge is at the bottom.

Remote control

Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.
INSTRUCTIONS FOR INSTALLATION
fig. 5a (Avanto)
fig. 5b (Concerto)
13
Tall edge
fig. 9
Avanto / Concerto