Foreword; Unpacking; Connection; Instructions For Installation - Dru Avanto Concerto Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its
natural draught draws in the combustion air from outside
through a combined inlet-outlet system.The same natural
draught expels the combustion gasses.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered installer.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance is suitable for G20 or G25 natural gas.
Please check that the local gas and pressure correspond
with the specifications on the type identification tag.The
type identification tag is a metal plate hanging on a chain.
All regulations regarding gas installation, including any local
regulations, must be observed at all times. The appliance is
to be installed by a registered installer.

Important

• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered installer.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to
dry.

Installing the appliance

The appliance is designed to be built into a new fireplace
(of incombustible and heat-resistant material) or flush with
the wall.To install the heater you will need to make a
rectangular recess.
Avanto 690-740 mm high and 610 mm wide
Concerto 690-740 mm high and 765 mm wide
The recess must also be also deep enough (400 mm).The
overall height will depend on how the feet are adjusted.
The fireplace should be built accurately with a view to the
narrow flange on the inside.
Lift the front panel out of the brackets. Remove the box of
logs and the bag of accessories from the combustion
chamber by opening the glass front.To do this, unscrew
the two socket-head bolts on the right of the glass, using
the socket-head spanner provided. Lift the glass out of the
brackets and position the heater as required.There should
be a little space all round the appliance in the fireplace to
allow the heat to escape; if this is not possible fit a
convection connection set, available as an accessory from
your dealer.The heater can also be installed in a corner,
see fig. 1 a+b for the space this requires.
Mantel iron
Packing
10
fig. 1a (Avanto)
fig. 1b (Concerto)
fig. 2