Charging The Battery; Switching The Product On And Off; Bluetooth ® Pairing - Hama Soundcup-Z Mode D'emploi

G Operating Instructions
Controls and Displays
1. On/Off, PAUSE button
2. MODE button
3. + function button
4. - function button
5. LED mode
6. Status LED indicator
7. Micro-USB charging connection
8. microSD card slot
9. AUX-In socket
10. USB Type-A (host) reader
11. Multicolour LED lighting
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for
future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to specific hazards and risks.
Note
This is used to indicate additional information or important notes.
2. Package Contents
• Mobile Bluetooth
Speaker Soundcup-Z
®
• Micro-USB charging cable
• 3.5 mm audio cable
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Do not use the product in the immediate vicinity of heaters or other
heat sources or in direct sunlight.
• Keep this product, as all electrical products, out of the reach of
children!
• Do not drop the product and do not expose it to any major shocks.
• Do not operate the product outside the power limits given in the
specifications.
• Do not use the product in areas where the use of electronic devices
is not permitted.
• Be considerate. Loud volumes can have a detrimental effect on your
surroundings.
• Do not open the device or continue to operate it if it becomes
damaged.
• Since the battery is integrated and cannot be removed, you will
need to dispose of the product as a whole. Do this in compliance
with the legal requirements.
• Keep the packaging material out of the reach of children due to the
risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
• Do not modify the product in any way. Doing so voids the warranty.
• Do not throw the battery or the product into fire.
• Do not tamper with or damage/heat/disassemble the batteries/
rechargeable batteries.
4. Getting Started and Operation

4.1 Switching the product on and off

• Press the Function button (1) to switch the speaker on/off. An
acoustic signal sounds and the buttons begin to light up / the lights
go out.
2
Note – Automatic shutdown
Note that the speaker will automatically switch off after 10
minutes without action (no audio playback/no Bluetooth
function).

4.2 Charging the battery

Warning – Rechargeable battery
• Only use suitable charging devices with USB connections for
charging.
• As a rule, do not use charging devices or USB connections that
are defective and do not try to repair them yourself.
• Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure (for
example, at high altitudes).
• When stored for a long period of time, batteries should be
charged regularly (at least every three months).
• Charge the speaker fully before using it for the first time.
• Connect the included Micro-USB charging cable to the speaker's
Micro-USB port (3).
• Connect the unused connector on the Micro-USB charging cable to
a suitable USB charger. Please refer to the operating instructions for
the USB charger used.
• The status LED (6) is constantly lit red during charging.
Note – Charging
• It takes approx. 3 – 5 hours to completely charge the product.
• The speaker's battery can be charged whether the speaker is
on or off.
• If the battery capacity is less than 10%, the speaker will emit
two acoustic signals. You will only receive this information if the
speaker is on.
• The actual battery life varies depending on use of the device, the
settings and the ambient conditions (rechargeable batteries have a
limited service life).
4.3 Audio playback via the included audio cable (3.5 mm jack)
• Ensure that the speaker is switched off.
• Connect your mobile terminal device (MP3 player, smartphone, etc.)
and the AUX input (9) of the speaker using the included 3.5 mm
audio cable.
• Set the volume on your terminal device to a low level.
• Switch on the speakers as described in 4.1, Switching the
product on and off.
• Start and control audio playback on the connected terminal device
accordingly.
• If the device does not automatically start in AUX mode, press the
Mode button (2) repeatedly until you are able to play audio from
the desired source.
• Briefly press the Plus button (3) to increase the volume. Briefly press
the Minus button (4) to reduce the volume.
• Briefly press the Function button (1) to pause playback.
4.4 Bluetooth pairing
®
Note
• Check whether your mobile device (MP3 player, mobile phone,
etc.) is Bluetooth capable.
®
• If not, you can only use the speaker for playback using the
included audio cable.
• Note that the maximum range for Bluetooth
without obstacles such as walls, people, etc.
®
is 10 metres
®