Operating Elements And Connections; Front Panel; Rear Panel; Safety Notes - Monacor PA-702 Mode D'emploi

GB All operating elements and connections described
can be found on the fold-out page 3.

1 Operating Elements and Connections

1.1 Front Panel

1 Volume controls for both microphone channels
2 Volume control for the PHONO/AUX channel
3 Tone controls
4 Master volume control
5 On/off switch

1.2 Rear Panel

6 Fuse holder; replace a blown fuse only by one of
the same type
7 Power cable for connecting to 230 V~/50 Hz
8 Connection terminals for a priority switch (make
contact). As long as the priority switch is kept
depressed, only microphone 1 can be heard (e. g.
for important announcements).
9 Connection terminals for speakers
10 Ground connection e. g. for turntables
11 Selector PHONO/AUX
12 Phono jacks as input for units with line level (e. g.
CD player, cassette deck)
13 Phono jacks as input for turntables with magnet
system
14 6.3 mm jacks for mono microphones

2 Safety Notes

This unit corresponds to all required directives of the
EU and is therefore marked with
WARNING The unit is supplied with hazardous
mains voltage (230 V~). Leave servic -
ing to skilled personnel only. Never
insert anything into the air vents. Inex-
pert handling may cause an electric
shock hazard.
During operation, dangerous voltage up to 100 V is
present at the speaker terminals (9). Always switch
off the amplifier before connecting it or changing any
connections.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
Do not place any vessel filled with liquid on the unit,
e. g. a drinking glass.
G
The heat generated within the unit must be carried
off by air circulation. Never cover the air vents.
6
G
G
G
G
G
G
.

3 Applications

This amplifier is designed to be installed in a small sys-
tem for general PA applications. It is possible to con-
nect different speaker combinations as desired via the
various output terminals (see fig. 3 – 8).
4 Installation
During installation pay attention that the air vents are
not covered and that air can circulate throughout the
unit to cool it.
Do not operate the unit or immediately disconnect
the plug from the mains socket
1. if there is visible damage to the unit or to the
mains cable,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled per-
sonnel.
A damaged mains cable must only be replaced by
specialized personnel.
Never pull the mains cable when disconnecting the
mains plug from the socket, always seize the plug.
For cleaning only use a dry, soft cloth; never use
chemicals or water.
No guarantee claims for the unit or liability for any
resulting personal damage or material damage will
be accepted if the unit is used for other purposes
than originally intended, if it is not correctly connect-
ed, operated, or not repaired in an expert way.
Important for U.K. Customers!
The wires in this mains lead are coloured in accord -
ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the ter minals in your plug, pro-
ceed as follows:
1. The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
or coloured green or green and yellow.
2. The wire which is coloured blue must be connect-
ed to the terminal which is marked with the letter
N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning - This appliance must be earthed.
If the unit is to be put out of operation defini-
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.