Installing The Transformer; Wiring; Connection Of An Electric Catch, Lock Or Of A Gate Motor; Technical Specifications - Extel WEPA 241 Guide D'installation Et D'utilisation

c. Installing the transformer (
fig. 4c)

- A ttach the transformer to a DIN rail in a modular fusebox or to a flat surface using the two black lugs clipped
to the sides of the transformer. (fig. 4c).
SAFETY INSTRUCTIONS
The transformer must be mounted to a DIN rail in a modular fusebox or surface-mounted on a non-metal
surface using the two mounting holes. The terminal block covers must be fitted. The unit should be connected
to an electrical installation meeting applicable standards (NFC 15-100 for France) AFTER WIRING IS COM-
PLETELY FINIShED.
Protection : The transformer is fitted with a thermal cut-out. If a fault or short-circuit occurs the following
steps should be taken to restore transformer protection.
1. Disconnect the 230 V~ power supply (for at least 2 minutes).
2. Repair as needed.
3. Reconnect the 230 V~ power supply.

WIrING

4
See the wiring diagram (fig. 5 for WEPA241 or fig.6 for WEPA242).
Wires to be used for WEPA 241 : • 2 wires 6 /10 mm up to 25 m
Wires to be used for WEPA 242 : • 4 wires 6 /10 mm up to 25 m
a. Connection of an electric catch, lock or of a gate motor
An electric lock or strike may be connected to terminals 9 and 10 on the roadside panel. To control an automatic
gate opener, connect the optional WE 8111 BIS unit between terminals 9 and 10 and the two «external control»
terminals on the automatic opener.
The strike, lock or automatic opener will be controlled by the
b. Connecting an optional extra WEPACB 243 indoor station
An additional WEPACB 243 handset may be connected in parallel with the main handset (fig. 7).
- Intercom between the two handsets (optional WEPACB 243) : The
cond handset and communicate discreetly. (Calls from the roadside panel are disabled while using the intercom
function)
5

TECHNICAl sPECIfICATIoNs

a. Indoor unit
(PACB 241 or PACB 242)
• Reference: 810243
• Power supply: 12V~
• Consumption: 12W
• Dimensions (mm): 210x70x40
b. Power supply
• Reference : 830241
• Tension : 230V~/12V~ 18VA
If the power supply cable is cut, check the polarity
3GB CFI EXTEL WEPA 241/242 - 09/2010 - V1
• 2 wires 1.5 mm up to 100 m
2
• 4 wires 1.5 mm up to 100 m
2
(fig. 5 ou 6)
button on the handset(s).
button can be used to call the se-
c. Outdoor unit
(PAPL 241)
• Reference: 820241
• Operating temperature:
-10°C until +45°C.
• Protection Index: IP44
• Front dimensions (mm) : 165x117x18

oPTIoNs

6
• Extra indoor unit: WEPACB 243 BIS
Any EXTEL electric catch
Any EXTEL electric lock
Any EXTEL gate motor
7

TECHNICAl AssIsTANCE - GArANTEE

Problems Possibles Cause
• The response unit does • The response unit is not
not light up under power
• No communication from • Obstructed microphone hole
outside to inside
If necessary, our technical website is at your disposal www.cfi-extel.com
HoTlINE : 0892-35-00-69 (0,337€ttc/min)
Last version of the dowloadable manual in color on :

GUARANTEE CONDITIONS :

This device is guaranteed for labour and parts in our premises.
The guarantee does not cover: the consumables (batteries, etc.) and the damages caused by: misuse, improper
installation, external intervention, deterioration by mechanical or electrical shock, fall or atmospheric phenomenon.
• If the device is opened, the guarantee is invalidated.
• If the device is sent back to SAV, protect it from getting scratched.
• Before cleaning, disconnect and switch off the video surveillance system.
• Clean with a soft cloth; do not use solvents.
Caution : Do not use any acid or alcohol based or other similar cleaning product or solvent. You may
damage the appliance and the vapours are explosive and dangerous for your health. Do not use any tool which
can be voltage conductor (metallic brush, sharp tool...or other) for cleaning.
The sales slip or the invoice is required as proof of purchase date.
CFI EXTEL WEPA 241/242 - 09/2010 - V1
Outdoor unit
(PAPL 242)
• Reference: 820242
• Operating temperature:
-10°C until +45°C.
• Protection Index: IP44
• Front dimensions (mm) : 165x117x18
Remedies
• Check that the adaptor plug is
properly inserted
• Clear the microphone hole
www.cfi-extel.com
4GB