Installing; Installing The Outdoor Station; Installing Of Monitor; Wiring - Extel LUKA Guide D'installation Et D'utilisation

6. Mic: allows visitors to communicate with those inside.
7. Removable terminal block to connect the wires

4. INSTALLING

Note: If you try the system before installing it, make sure the street unit and the monitor are not in the same
a. Installing the exterior outdoor station
3. The lens of the panel must be placed at a height of approx. 1.60 m.
5. Connect wires according to wiring diagram.
Important ! Do not point the video camera directly at the sun or at reflecting surfaces.
Tip: we recommend passing the cables through a protective sleeve to shield them from impacts and the weather.
b. Installing the monitor
2. Connect the wires from the street unit.
5. Connect the power supply unit plug to the 230 V wall connector.
Note: If the power supply cable has to be cut, ensure that the colour coding of the wires is maintained when

5. WIRING

wires.
Caution : In any case, do not double the wires to increase size
If there is a short circuit on the line a protection is triggered. Disconnect and reconnect the power supply after
10 seconds
a. Connecting the videophone
Use the following wires:
2. To connect the camera, only 2 wires are necessary for all the functions: ring tone, video image, door phone and
door-opener control (
Observe the polarity between the screen and the external camera (no polarity is to be observed for the door-
Important :
CFI EXTEL LUKA / MIKA - 12/2014
wires
2
GB3