Setting The Operating Mode - Arbonia WFS Série Instructions D'utilisation Et De Montage

W If the LED (7) lights up continuously for
approx. 5 seconds, the teach-in process has
failed. Restart the teach-in process.
W
D9: Install splash protection cover
The LED (8) displays the operating mode of the
electric heating element.
Status
Red light
Yellow light Setpoint temperature has been
reached, electric heating element
Flashing red Radio communication impaired,

3.11 Setting the operating mode

In the as-delivered condition, the thermostat
is programmed for regulating the room tem-
perature. If radiator temperature control inde-
pendent of the room temperature is desired
(e.g. because the room temperature is control-
led via panel heating), execute the following
steps according to Fig. F1 – F3:
W Remove the housing cover (5) carefully.
W Remove battery (6).
W Set the rotary switch (1) to the "1"
position.
W
Use battery (6) with boost button (3)
pressed.
– LED display (4) indicates the conversion
by flashing yellow.
– Display of the operating mode goes out.
– Towel warming mode is active.
W Re-attach the housing cover (5).
If regulation of room temperature is desired
instead of towel warming mode, repeat the
02/2019
Meaning
Heating phase
is switched off
check thermostat WFS
above mentioned steps. For this, set the tem-
perature controller (1) to the "
LED display (4) displays the conversion by flas-
hing red.
Position of the temperature controller (1)
– "
f
"
= Room temperature control mode
– "1" = Towel warming mode
Display of the set operating mode
W Keep the boost button (3) pressed for
approximately 10 seconds.
– LED display (4) flashes red
room temperature control operating
mode
– LED display (4) flashes yellow
towel warming operating mode
– Display of the operating mode goes out.
– The thermostat is ready to operate.
Thermostat WFS
Installation
f
" position. The
13