Conditions Of Use - Arbonia WFS Série Instructions D'utilisation Et De Montage

Warning
Danger of death from electric shocks!
W Only install and connect the unit when it
is de-energized.

3.2 Conditions of use

W Only install thermostat in conjunction with
electric heating elements from the manu-
facturer's product range.
W Ensure that the output of the electric hea-
ting element does not exceed the output of
the radio receiver (see nameplate).
W When installing in rooms with bath or sho-
wer facilities: comply with protective areas
according to national installation standards
(in Germany DIN VDE 0100-701). Also fol-
low all local regulations.
W During installation, a residual-current-ope-
rated protective device (with trigger limit
less than or equal to 30 mA) must be pro-
vided on-site.
W If a unit is connected directly to the fixed
electrical installations: incorporate a dis-
connecting device in accordance with the
local regulations for mains disconnection.
W Only operate the unit with the approved
voltage (see nameplate).
W Only store and transport the unit in the pro-
tective packaging.
3.3 Complaints
Please contact the supplier.
02/2019
3.4 Disposal
Packaging and any parts that are not needed
should be recycled or disposed of properly.
Observe local regulations.
3.5 Technical features (see nameplate)
W Corresponds to the standard EN 60730-1,
-2-9
W Batteries thermostat: 2 x 1.5 V, type LR03
or AAA
W Radio frequency: 868 MHz
Performance data radio receiver
Nominal voltage
Output cross section
recommended wire end
ferrules
Maximum switching
capacity
Load rating of contact
Power consumption in
stand-by mode
Insulation type wall
outlet
Protection type wall
outlet
Operating principle
Degree of soiling
Rated surge voltage
3.6 Protective areas in rooms with bath
or shower facilities (for installation
examples, see Fig. A)
W According to national installation standards
(in Germany DIN VDE 0100-701), electrical
equipment may only be installed in specific
Thermostat WFS
Installation
230 V AC
1 x 1.5 mm²
L = 10 mm according to
DIN 46228
1800 W
8 A / 250 V ~ at cos = 1
or
2 A / 250 V ~ at cos = 0.6
approx. 0.9 W
Protection class I or
Protection class II
IPX4 after proper instal-
lation
Type 1B
II
4 kV
11