Cleaning And Maintenance; General Information - Reely ROAD Monstertruck Detonator Notice D'emploi


10.

Cleaning and Maintenance

a) General Information
Before cleaning or servicing, turn the speed controller off and completely disconnect the drive battery from
the speed controller. If you have driven the vehicle before, let all parts (e.g. motor, speed controller, etc.)
cool down completely first.
Clean the whole vehicle of dust and dirt after driving, e.g. with a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and
lead to discolouration of the plastic parts or the body.
Never wash the vehicle with water, e.g. using a high-pressure cleaner. This will destroy the motor, as well
as the servo, speed controller and receiver you installed. The vehicle must not become damp or wet!
A soft cloth, slightly dampened, can be used to wipe the car body. Do not rub too hard to avoid scratch marks.
At appropriate intervals, you should perform maintenance work and function checks on the vehicle. This
ensures trouble-free operation and road-worthiness for a long time.
Motor vibrations and shocks during driving can loosen parts and screw fittings.
Therefore, check the following items before and after driving:
• Tight fit of wheel nuts and of all vehicle screw fittings
• Attachment of speed controller and receiver
• Glue-connections of tyres and rims or tyre condition
• Attachment of all cables (they must not get into movable parts of the vehicle)
Also check the model for damage before each use. If you notice any damage, the car may not be used
anymore and has to be taken out of operation.
Only original spare parts must be used to replace worn vehicle parts (e.g. tyres) or defective vehicle parts
(e.g. a broken transverse link).
42