PLYMOVENT DRAFTMAX BASIC Manuel D'installation page 9

WARNING!
It is necessary to apply the bolts to ground the work
grids.
• Place the bars (C).
The supplied standard work grid and the ground bracket become
redundant.
A
B
C (x26)
Fig. 4.4: Mounting of plasma cutting work grid
4.2.6 HEPA kit
ATTENTION!
Handle HEPA box and filter cartridge with care during
unpacking and mounting to avoid damage.
The HEPA kit consists of:
- HEPA box with filter
- 2 adjusting feet
- 4 spare bolts M6
- draught strip
To mount the HEPA kit, proceed as follows.
Fig. 4.5
• Unscrew the outlet panel of the downdraft table; keep the 4
bolts.
• Apply the draught strip to the downdraft table (A).
• Unlock the HEPA filter cartridge by pressing a screwdriver or
other tool at the position of the strips (B) .
0507060400/151013/G DraftMax Basic | DraftMax Advance | DraftMax Ultra
• Take out the filter cartridge.
• Mount the adjusting feet underneath the HEPA kit.
TIP

Remove the outlet panel of the HEPA kit, as well as the
outlet grid inside the downdraft table, to facilitate
mounting.
Don't forget to place them back afterwards.
• Place bolts halfway through the 2 upper holes at the outlet
of the downdraft table (C).
• Hang the HEPA box on the bolts.
• Place bolts through the 2 lower holes in the HEPA box (D).
• Fasten the HEPA box by tightening the 4 bolts (C+D).
• Place the filter cartridge.
• Lock the filter cartridge by pulling the two straps tightly. This
is indicated by a click sound.
If a Silencer/Outlet duct has to be installed as well, the

outlet panel of the HEPA kit does not need to be
mounted and becomes redundant.
• Adjust the adjusting feet when the downdraft table is placed
at its final position.
The outlet panel of the downdraft table becomes redundant
anyway.
A
C (x2)
Fig. 4.5: Mounting of HEPA kit
4.2.7 Silencer/outlet duct
The Silencer/Outlet duct consists of:
- upper shaft with top grid
- lower shaft
- draught strip
- bolt (6)
B (2x) B (2x)
D (x2)
EN - 8