Brandt DWE350 Notice D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Selecting a washing programme
Starting the washing cycle
After programming the machine, press the
"START" button.
This button does not remain pressed in.
The programme starts immediately if delayed
start has not been selected (indicator lights 3 -
9 hours unlit).
Selecting delayed programme
start
After selecting your programme, press the
"Delayed Start" button.
If you wish to delay the start by 3 hours, the
relevant light illuminates.
Press the button again for a 9-hour delay
(pressing the button after a 9-hour delay is
indicated, selects immediate start).
Press the "Start" button.
The 3-hour or 9-hour light remains lit until the
programme starts.
Cancelling a programme
To do this, press the "Start" button
for 2 seconds. The programme stops, the
progress light goes out and the "Stop" light
illuminates.
End of programme
The programme is ended when the "Stop" light
illuminates.
You can then remove your crockery.
The selected programme and the selected
"Condenser Drying"
memory at the end of the cycle.
If you wish to cancel the option, press the
button again. The indicator light will go out.
Selecting option
or
First select the washing programme (position
70°C to 45°C). The selected programme will
adapt itself to the chosen washing option.
Press the button for the chosen option. The
relevant light illuminates and goes out at the
end of the cycle.
If you wish to cancel the chosen option, press
the button again. The light will go out and you
can then select a new option, if required.
Rapid wash
A rapid programme recommended for slightly
dirty crockery, not greasy and composed of
fragile items.
"Condenser Drying" option
To complete the drying of the various items of
crockery, your machine is equipped with a
condenser drying system.
This process dries your crockery perfectly, with
no steam when you open the door.
LThe missing product indicator
lights
Salt:
have added regenerating salt it may stay on
until the salt has dissolved sufficiently. This
happens generally after a cycle (or if you have
not properly filled the machine – see page 4)
for example when starting off with the sample.
Note: where water is particularly soft
down
regenerating salt is not needed but the light will
remain on.
Rinsing product:
when you should add rinsing product (see filling
page 5)
Economical and ecological washing
Do not pre-wash your dishes by hand.
Use all the capacities of your dishwasher. It will
wash economically and ecologically.
option remain in
Always choose the programme best adapted to
the stains and the type of dishes.
Avoid using too much detergent, regenerating
salt and rinsing liquid. Observe the
recommendations contained in this manual
(pages 5, 6 and 7) as well as the product
manufacturer's instructions.
Make sure that the water softener is properly
adjusted. (see page 4)
GB
go on when the machine is turned on.
lights up when salt is low. After you
Goes on, door ajar,
9

Publicité

Table des Matières
loading

Table des Matières