Troubleshooting - Brandt DWE350 Notice D'utilisation

Troubleshooting

Problems
The dishwasher will not start
The dishes are not properly washed (or
their are stains in it)
Greasy stains
Limescale deposits on the dishes
The dishes are dull
Traces of salt (salty taste on the dishes)
Blackened or marked silverware
Traces of rust on knife blades
The dishwasher does not empty
If you have problems not covered by these
remarks, consult your dealer or After-Sales
Service. Have the machine type, series
number or that mentioned on the rating plate
(inside the door) ready.
You will so avoid unnecessary delays and
cost.
Causes
- Is it plugged in ?
- Is the door properly closed ?
- Is the water connected ?
- Check that the "delayed start" is on "0" (according to the model)
- Programme choice. Choose the programme best adapted to the
type of wash
- Make sure nothing is blocking the circulation of the water
- Check the dishes are properly arranged.
- Only use specially designed washing products
- Check the waste well, filters, arms, joints and door rim are clean
- Clean the filter
- Check that the washing arm can freely rotate
- Increase the dose of washing product
- Use a new packet of washing product
- Choose a better adapted programme
Check it is limescale (clean with vinegar). If yes :
- Check the hardness of the water
Too soft water is aggressive for glasses.
- Check the hardness of the water
- Reduce the softener and if necessary remove the regenerating
salt.
- Add water to the salt pot and reload if necessary.
- Cap badly closed.
- Remove food residue immediately after use
- Separate silverware from other metals
- Choose detergent recommended for silverware
- Use knives suitable for dishwashers
- Remove the siphon stop valve
- Check the drain pipe is not bent or crushed
- You have moved your dishwasher and have tipped it backwards. To
restart the pump, unhook the draining rod, lay it on the floor at the
end of a basin, draining should restart. Then turn off the "Start/Stop"
button, put the draining rod back and restart your programme.
This machine complies with all applicable safety standards. Any
repairs should be carried out by a qualified technician. Repairs
carried out by unqualified technicians may be dangerous for the user.
GB
11