Free-Standing Set-Up; Inserting The Battery In The Remote Control; Connecting The Device - Medion LIFE E66314 Mode D'emploi

ATTENTION!
Never mount the device above a cooker or any other heat
or steam source. Never allow the mains cable to hang over
a heat source.

6.2. Free-standing set-up

Instead of mounting the device on a cupboard/shelf, you can also put it on a table
or a cupboard without having to fix it permanently into place.
 Place the device on its feet on a stable, level surface near a mains socket.

7. Inserting the battery in the remote control

The remote control works with one 3 V button battery, type CR2025.
WARNING!
There is a risk of explosion if batteries are replaced in-
correctly.
Replace batteries only with the same or equivalent
type.
 Slide down the battery compartment cover on the back of
the remote control. Remove any spent batteries by pushing
them down and out of the guide and dispose of them at a
collection point for used batteries.
 Insert a fresh CR 2025 battery into the battery compartment
with the positive pole facing up. Ensure the +/− terminals
are correct.
 Replace the cover.

8. Connecting the device

Before connecting the radio, switch it off using the power switch at the side of the
unit.
 Operation of the FM/DAB radio: Adjust the aerial at the rear of the device for re-
ception.
 Mains adapter: Connect the connector plug on the supplied mains adapter to
the DC IN port and plug the mains plug into an AC 230 V ~ 50 Hz socket.
 LINE OUT: Connect a 3.5 mm stereo jack to the LINE OUT socket to transfer the
stereo sound output of the radio to other audio devices.
 AUX IN: Connect a 3.5 mm stereo jack to the AUX IN socket to play back stereo
sound output from other audio devices via the radio.
DE
FR
NL
DK
EN
113 of 124