Ryobi POWERMULCHING RBV2800S Traduction Des Instructions Originales page 13

Deutsch (Übersetzung der originalen Anleitungen)
TROUBLESHOOTING
PROBLEM
Motor won't start
Material is not
sucked in properly
(reduced
vacuuming power)
DIPOSAL
MAINTENANCE AND STORAGE INFORMATION
Prior to cleaning or any maintenance, always ensure the power plug has been removed from the electric power supply.
When you have finished using the blower vac, always check to make sure the product is clean and free of dirt and
debris. It is especially important to check and clear debris around the quick change lever. To check this area, remove
the collection bag and ensure the discharge side of the tube is free of debris and dirt. Operate the selector lever
backwards and forwards to ensure correct operation
Do not use solvents to clean the blower vac.
„
Store the blower vac in a dry place, and out of reach of children.
„
POWER CORD MAINTENANCE
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.
English (Original instructions)
POSSIBLE CAUSE
1. No mains power (power failure)
2. Connection lead wire defect
3. Motor or switch defect
4. lower tube hasn't been telescoped out to
its full length.
1. Machine is clogged or blocked
2. Bag too full
3. Speed setting too low (only for garden
vac with fully variable speed control)
Waste electrical products should not be disposed of together with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling advice.
SOLUTION
1. Check fuse (13 A)
2. Replace lead or have lead checked
(electrician), never use defect lead
3. To solve the problem, contact the
manufacturer or Service centre (see
customer service list)
4. Pull the lower tube out to its full length.
1. Clean machine
2. Empty bag
3. Adjust to higher speed
11 11