Ryobi POWERMULCHING RBV2800S Traduction Des Instructions Originales page 11

Deutsch (Übersetzung der originalen Anleitungen)
CE conformity
GOST-R conformity
SPECIFICATION
Type
Voltage
Frequency
Input Power
Insulation
Air velocity
Air volume
Net weight
(without cable)
Mulching Ratio
Measured sound
pressure level;
Measured sound
power level;
Vibration level
DESCRIPTION
Figure 1
1. Shoulder Strap
2. Trigger
3. Rear handle
4. Livetool Indicator™
5. Quick change lever
6. Collection bag holder
7. Power Cord
8. Collection bag
9. Guide wheels
10. Front bracket
11. Lower tube
12. Upper tube
13. Front handle
14. Motor housing
15. Variable speed control (Model RBV3000VP only)
16. Tube lock button
Figure 2
17. Upper tube latch
18. Lower tube latch
Figure 3
English (Original instructions)
RBV2800S RBV3000VP
220-240 V~
50 Hz
2800 W 3000 W
Class II
320 km/h 270-320 km/h
14 m³/min 11-14 m³/min
5.5 Kg
15:1
L PA :92.5 dB(A);
K PA :2.0 dB(A)
L WA :108 dB(A),
KwA=2 dB(A)
a h : 4.6 m/s²; K:1.5 m/s²
16. Tube lock button
Figure 4
19. Bag connector with handle
20. Collection bag front hook
21. Shoulder strap connection hook
22. Debris Outlet Tube
ASSEMBLY
UNPACKING
Carefully remove the product and any accessories
„
from the box.
Inspect the product carefully to make sure no
„
breakage or damage occurred during shipping.
Do not discard the packing material until you have
„
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call your
„
Ryobi service centre for assistance.
T h e b l o w e r v a c i s s u p p l i e d w i t h s o m e
„
components not assembled. To assemble these,
proceed as follows:
ATTACHING AND EXTENDING THE TUBE (Fig. 2, 3)
Slide the tube into the motor housing (14).
„
Ensure that the latches (17 and 18) are closed and
„
securely hold the tube and motor housing together.
Push the tube lock button down (16 in figure 3) and
„
pull the lower tube out of the upper tube by holding
the front bracket (10) to fully telescope the tubes out.
You will hear a >>click<< sound when the tubes are
fully extended and lock into place.
ATTACHING THE DEBRIS OUTLET TUBE(Fig.4a)
CAUTION:
Do not operate the machine without having
attached the debris outlet tube to the unit.
The debris outlet tube(22) is fixed by one time snap fit.
Insert the tube into motor housing(14), and it will be
locked into place when you push it to the end.
ATTACHING AND REMOVING THE COLLECTION BAG
(Fig. 4b)
CAUTION:
Do not use the product in vacuum/suction mode
without the collection bag fully assembled and
properly attached to the unit.
Align the front part of the plastic bracket on the
„
collection bag with the discharge outlet of the blower
vac (on the tube side)
Align and push the bag connector on the rear side
„
(19) into the discharge outlet of the blower vac until it
clicks into place.
9 9