dirna Bergstrom Bycool Blue Série Instructions De Montage page 12

FLAT
EN ES
RECOMMENDATIONS
FOR ASSEMBLY
•Before starting the assembly read the instructions
and follow them during the installation process.
• Use suitable tools for each operation.
ELECTRICITY
• Switch off the ignition key.
• Disconnect the battery before starting the
assembly.
• Secure the connection of the electrical compo-
nents by checking that they fit correctly.
WARNING :
When installing the evaporative unit in the ceiling,
protect the upper part of the cabin with a cloth
or sheet to prevent scratching. When installing
Bycool Flat in the ceiling, bear in mind that
cabins are normally fitted with a hatch and have
a structure which can withstand the weight of the
unit. However, if this is not so and it is necessary
to open up the ceiling, or should the hatch
material not be sufficiently resistant (e.g. fibre,
plastic, etc) the installer must decide, under his
sole responsibility, on the need to reinforce the
ceiling in order to prevent deformation, breakage,
incoming water, etc, and use the means necessary
to this end.
Torque Wrench set
Allen Wrench Set
Spanner 10
Spanner 13
Spanner 14
Scissors
Tape Measure
DOCUMENTATION WHICH COMES
WITH THE EQUIPMENT:
• Assembly Instructions: 220.AA7.0035
• User Manual: 220.AA7.0003
• Troubleshooting: 220.AA7.0004
• Guarantee: 220.AA1.0010
WARNINGS :
• Part no. 17 from the List of Parts Supplied must be
replaced every 12 months.
• Dirna, s.a. will not be held responsible for any
faults arising from inappropriate handling or
installation of the equipment, or due to modifications
or replacements carried out without our written
authorisation.
• See guarantee procedure for the product included
in Troubleshooting.
• See the equipment User Manual for the correct
operation of the remote control and the control
panel.
12
Tools
®