Siemens TE502 Série Mode D'emploi page 24

en
Problem
Display shows
Error
Call hotline
The water filter does not
stay in position in the water
tank (16).
Display shows
Check water tank
The coffee grounds are not
compact and are too wet.
Display shows
Clean brewing unit
Coffee or milk froth quality
varies considerably.
Water dripped onto the
inner floor of the appliance
when the drip tray (8) was
removed.
Display shows
Insert brewing unit
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
20
Cause
The appliance has a fault.
The water filter is not
mounted correctly.
Water tank has been
incorrectly inserted or the
new water filter has not
been rinsed according to
instructions.
Carbonated water in the
water tank.
The grinding setting is too
fine or too coarse, or not
enough ground coffee has
been used.
Brewing unit (5) is soiled.
Too much pre-ground coffee
in the brewing unit (5).
The brewing unit's mecha-
nism is stiff.
Build-up of limescale in the
appliance.
Drip tray (8) removed too
early.
Brewing unit (5) is missing or
was not recognised.
Solution
Please call the hotline.
Firmly press the water filter
straight down into the tank
connection.
Insert the water tank correctly
or rinse the water filter
according to instructions and
then switch on.
Fill the water tank with fresh
tap water.
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Clean brewing unit (5).
Clean brewing unit (5) (pour
in no more than 2 level meas-
uring spoons of ground coffee).
Remove and clean the brewing
unit, see "Maintenance and
daily cleaning".
Descale the appliance as
described in the instructions.
Wait a few seconds after
the last drink was dispensed
before removing the drip tray
(8).
Switch off the appliance with
the brewing unit (5) in place,
wait three seconds and switch
on the appliance.