Table des Matières
Publicité
DO2723CG
INSTALLATION
Remove all packing materials and accessories. Examine the oven for any damage such
as dents or a broken door. Do not install if the oven is damaged.
Remove any protective film found on the microwave oven cabinet surface.
1. Select a level surface that provides enough open space for the intake and/or outlet
vents. A minimum clearance of 20 cm is required between the oven and any
adjacent walls. One side must be open. Leave a minimum of 30 cm clearance
above the oven.
2. Do not remove the legs from the bottom of the oven.
3. Blocking the intake and/or outlet openings can damage the oven.
4. Place the oven as far away from radios and TV's as possible. Operation of the
microwave oven may cause interference with your radio or TV reception.
5. Plug your oven into a standard household outlet. Be sure the voltage is the same
as the voltage on the rating label of your appliance.
Warning: Do not install the oven over a stove or another heat-producing appliance.
If installed near or over a heat source, the oven could be damaged and the
warranty would be void.
The accessible surface may be hot during use.
OPERATION INSTRUCTION
1. Clock setting
1. When the microwave oven is plugged in, the oven will display „0:00", the buzzer
will beep once and the oven will enter the waiting state. Its setting range is 0:00 -
23:59.
2. When in waiting state, press „Stop/clear/clock" and „00" will flash. At the same
time „ : " will light.
3. Turn the knob to input the hours. Its range is 0-23.
4. Press „start" to confirm the clock.
5. Turn the knob to input the minutes. Its range is 0-59.
6. Press „start" to confirm. „ : „ flashes.
To modify the clock, follow the same steps as described above.
Note: If you press „Stop/clear/clock" during the clock setting process, the microwave
will exit the time setting mode.
2. Microwave cooking
1. Select the desired microwave power level and set the cooking time. There are 5
different power levels available. Keep on pressing „microwave" to select the right
power level.
2. Press „microwave". The display will show „P100" first and the „
60
„ indicator
Publicité
Table des Matières
