Listening To The Memorised Station - Sharp CD-CH1500W Mode D'emploi

Listening to the Memorised Station

! Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
1
Perform steps 1 - 3 in the "Listening to the Radio" section on page
21.
2
Press the ENTER button to enter the preset tuning saving mode.
3
Within 5 seconds, turn the jog dial to select the preset channel
number.
" Store the stations in memory, in order, starting with preset channel 1.
" When " " is displayed, a station has already been stored in memory.
4
Within 5 seconds, press the ENTER button to store that station in
memory.
" If the "MEMORY" and preset number indicators go out before the station is memo-
rised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
" When a new station is stored in memory, the station previously memorised will be
erased.
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
! To recall a memorised station
Turn the jog dial to select the desired station.
Note:
The PRESET ( or ) button on the remote control allows you to recall a memorised
station.
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
1
Press the PRESET ( or ) button on the remote control for more
than 0.5 seconds.
" The preset number will flash and the programmed stations will be tuned in
sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the desired station
is located.
! To erase all the contents of the preset
memory
1 Press the TUNER (BAND) button.
2 Press the ENTER button.
3 Press the CLEAR button.
4 Whilst "ALL CLEAR" is displayed,
press the ENTER button.
To erase only one station:
Recall the memorised station. Whilst it is displayed, press the CLEAR button. Whilst
"CLEAR" is displayed, press the ENTER button.
01/1/25 E2.fm
ENGLISH E-22