GCE MM40 Mode D'emploi page 7

P11 P12
EN
P3 V13 V14 P4
H1
Fig. 2
5.2.1. GAS MANIFOLD HIGH PRESSURE ACCESSORIES
P3, P4 - CONNECTION POINTS
The accessories contains two connecting points for connecting to the pipelines.
P11, P12 – COLLECTING PIPES
Collecting pipes are used for connecting gas cylinders to the manifold. Two equal parts one left
and one right of these pipes should be included to the HP unit.
V13, V14 – INLET SHUT OFF VALVES ON COLLECTING PIPES
If collecting pipes are used, inlet shut off valves and antishock valves shall be included. Shut off
valves stops the gas supply between each cylinder and the collecting pipes. Antishock valves
prevent a back flow, they are not leaktight.
H1 – CYLINDERS HOLDERS
The accessories can contain cylinders holders. Cylinder holders are used for prevention of the
gas cylinders from falling over.
6. INSTALLATION
It is necessary that an installer of the product is trained and has an appropriate licence ac-
cording to national standards. It is outside the scope of these operating instructions to give
detailed guidance on installations.
The installation must conform to the standard MEDICAL GAS PIPELINE SYSTEMS EN ISO
7396-1 as amended. All tests according this standard have to be fulfilled.
7/164