Technical Specifications - Femi 350 PLUS Mode D'emploi Et Entretien

L
B
C
I
G
A
2 INSTALLATION
2.1

TECHNICAL SPECIFICATIONS

Voltage: ............................................................ 230 volts
Power: ... .. ................................................900 watts
Number of revs: ........................................2970 rpm
Airflow: ...................................... 500 CFM/14.15 m
Fan diameter: ..................................................... 300 mm
Dimension of the sucking base: .................... Ø 100 mm
Dimensions of the bag: .....................Ø 370mm x h640mm
Bag volume: ...................................................... 0.057 m
Average sound level: ............................ Lpm = 76 db (A)
Weight: .................................................................... 30Kg
2.2
Remove the box used for protecting the machine during
E
transport. Exercise the greatest caution not to damage the
packing as you might need it again to move the suction
fan or store it for long periods of time.
H
D
2.3
Your suction fan must be fully assembled before using it.
E
The instruction manual must be read before using the
machine to get to know it well before beginning the job.
Prepare the various parts to be assembled
1. Fit the four wheels in the four corners underneath the
F
Fig. 1
3 /min.
3
REMOVING THE PACKING
WARNING:
Do not start the suction fan until it has been
completely assembled and until all the operating
instructions have been fully read and
understood
ASSEMBLY
rectangular base using the screws and nuts with the
relevant washers. For each wheel-supporting corner
you should insert over a screw through the washer in
the base and then in the support of each wheel. Tighten
the nut using a specific wrench and a screwdriver.
Repeat the operation for the other wheels. The two
directional wheels are to be located on the side of the
bags opposite the motor (Fig. 2).
Fig. 2
9