Connection; Configuration; Version - Beyerdynamic CA 4588 Notice D'utilisation

CA 4588 – Operation
2. Connections
Network connection
• Connect one of the NetRateBus sockets
The CA 4588 Digital/Analogue Interface will be powered by the control unit.
Digital audio connection
• You can connect e.g. digital audio recorders or mixing consoles to the AES/EBU output
Analogue audio connection
• You can connect e.g. wireless microphones or any reproducer to the analogue inputs of the 12-pin
Phoenix connector
• You can connect e.g. recorders, mixinig consoles or amplifiers with balanced inputs to the analogue
outputs of the 12-pin Phoenix connector
establish an electrical connection between the "Cold" and "Shield" pins.
Pin assignment of Phoenix connectors on the rear of the CA 4588
3.

Configuration

The following settings must be adjusted:
• Set an identification number (logical address) for each of the three interface units
• Assign channels for CH 1/2 IN (inputs) and CH 1/2 OUT (outputs) of the interface units
• Adjust the level of CH 1/2 IN (inputs) and CH 1/2 OUT (outputs)
• Switch on/off the CH 1/2 IN (inputs) and CH 1/2 OUT (outputs)
Warning: Unused DAI inputs must be OFF, to avoid noise!
You can adjust these settings in the DAI/DDI MANAGEMENT menus of the MCS-D 200 control unit or with
the iCNS conference software. For more information, please refer to the appropriate manuals.
4.

Version

CA 4588 Digital/Analog Audio Interface, 6 IN, 6 OUT, 3 x Stereo-AES/EBU Out,
2 Push-Pull connectors, 19" housing, 1 U . . . . . . . . . . . . . . . . . . . . . . Order # 722.677
to the control unit e.g. MCS-D 200.
.
. If you use devices with unbalanced inputs, you must
13
.