Electrolux LCB1AF10W0 Notice D'utilisation page 15

Problem
The appliance is noisy.
Temperature indicator
flashes from left to right.
The lid does not close
completely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
Possible cause
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The appliance touches the
wall or other objects.
Temperature sensor error.
Food packages are block‐
ing the lid.
There is too much frost in
the appliance.
The lid gasket is dirty or
sticky.
The lamp is defective.
Temperature is set incor‐
rectly.
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is
too high.
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The SUPER function is
switched on.
ENGLISH
Solution
Check if the appliance is
plugged correctly.
Connect the appliance to a
different electrical mains
socket. Contact a qualified
electrician.
Check if the appliance
stands stable. Refer to
"Location" section.
Slightly move the appli‐
ance. Refer to "Location"
section.
Contact the Authorised
Service Center.
Arrange the packages in
the right way.
Defrost the appliance. Re‐
fer to "Defrosting the freez‐
er" section.
Clean the lid gasket.
Contact the Authorised
Service Center to replace
the LED light.
Refer to "Temperature reg‐
ulation" section.
Wait a few hours and then
check the temperature
again.
Refer to the climate class
chart on the rating plate or
to the "Positioning" sec‐
tion.
Allow food to cool to room
temperature before stor‐
ing.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Refer to "SUPER function"
section.
15