ECOFOREST NETFLAME MXS 00-02 Manuel D'utilisation page 29

Although we cannot keep track of or describe every single installation, option, or the local installation
regulations corresponding to your area, NETFLAME guarantees that the installations suggested below will enable
your stove to function properly, and to conform to minimum personal and material safety measures.
If you are installing your stove in a building, in addition to respect local regulations on gas flues, you should
consult with the residents' association to avoid future problems.
Please read the entire manual carefully, especially the chapter on installation to ensure your stove
operates properly and at full power.
If the total pipe length exceeds 8m, it is recommended to increase one measure, being able to make the
whole assembly in the same diameter from the connection of the stove or increase section from 4 m.
4.24. The installation shown below is the most common. Please bear in mind that if the gas flue pipe located on
the outside of the dwelling is in an area where people pass by, insulated tube must be used.
Windbreak.

Stainless steel hose clamp.

T of 135° with outlet.

Elbow of 45°.

Insulator.

Wooden ground.

Non flammable floor protection.

*Distance equal to or less than 2 metres.

* If the tube over 4 m in length, the next larger
size will be used.
4.25. If for aesthetic, safety or municipal regulations we cannot install the stove as described above, we can always
install the pipe on the inside of the dwelling, paying special attention to the areas where the pipe touches
structures, and the minimum vertical and maximum horizontal lengths.
Windbreak.

Stainless steel hose clamp.

T of 135° with outlet.

Elbow of 45°.

Insulator.

Wooden ground.

Non flammable floor protection.

Elbow of 90°.

*Distance equal to or over 2 metres.

MAXIMUM 1 metre.

EXAMPLES OF FLUE INSTALLATIONS.
28
Drawing 5
Drawing 6