Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Connect the device to the line voltage.
3. Suspend the extension cable from the
belt clip (
14) and fasten it to the
trouser belt.
4. To switch the device on,
press the release button
(12) on the handlebar (1)
and pull the start lever (13)
towards the handlebar (1).
Let go of the release button (12).
The choppers (9) will begin to rotate
and start digging into the ground.
5. To switch off, let go of the start han-
dle (13).
Attention! The choppers (9)
will keep rotating for a few sec-
onds after the device has been
switched off. Do not touch the
rotating choppers (9).
There is a risk of injury.
Setting the working
widths
The device can be set to 2 working
widths, see
"Replacing choppers".
1st working width:
2nd working width:
Operating instructions
Always keep a firm grip on the
tool with booth hands and watch
your feet.
The choppers (9) may cause
an accident. Be careful while
moving backwards – danger of
tripping!
Do not touch the gearbox, as it
may become hot during opera-
tion – danger of burns!
2
1
365 mm
190 mm
Switch the tool off after working
with it and for transport; disconnect
from the mains and wait for the
choppers (9) to stop moving.
To avoid damage to the tool:
• Never lift or drag the tool with
the motor running.
• Lift the tool while moving it over
hard surfaces such as tiles or
steps.
• Walk the tool through the soil
at normal pace and in a line as
straight as possible.
• Always work away from the
mains socket. Make sure that
the cable is kept well away from
the working area. Hanging the
cable into the belt clip (14) in-
cluded in the package will help.
Overload protection: The motor
will cut out immediately if overload-
ed. The tool cannot be used until it
has completely cooled down again.
Cleaning/Maintenance
Always return the tool to the ser-
vice centre for work not described
in the manual. Only use original
parts.
Switch the tool off, unplug it from
the mains, and wait for the chop-
pers (9) to stop moving before
carrying out any maintenance or
cleaning work on the tool.
Perform regular maintenance and clean-
ing on the tool. This will ensure long, reli-
able service.
GB
71
Publicité
Chapitres
Table des Matières
