Care And Maintenance; Troubleshooting Guide; Fcc Compliance Information - Beurer MG 134 Mode D'emploi

7. Care and Maintenance

WARNING
• Before cleaning, unplug the power adapter from the electrical outlets and disconnect it from the device.
• Only clean this device as described. Keep water and other liquids out of the device and accessories.
Small marks can be removed using a cloth or damp sponge and mild detergent. Do not use solvent-based
cleaning products. Let dry completely before reuse.
If not using the device for a long period, store it in the original packaging in a dry location. Do not place any
heavy objects on it while in storage.

8. Troubleshooting Guide

Problem
Massage heads rotating
at reduced speed.
Massage heads not
moving.
9. Specifications
Power Supply
Dimensions
Weight

10. FCC Compliance Information

Shiatsu massage cushion MG 134
Responsible Party U.S. Contact Information:
Beurer North America LP
1 Oakwood Boulevard, Suite 255
Hollywood, FL 33020
United States
1-800-536-0366
info@beurer.com
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
Cause
The load on the massage
heads is too great.
Device not plugged in.
Input: 100-240 VAC, 50/60 Hz, 0.5 A
Output: 12 VDC, 1.5 A, 18 W
15.75 x 15.75 x 4 in (40 x 40 x 10 cm)
About 4 Lbs (1.8 kg)
Solution
Reduce pressure on the massage heads.
Plug the power adapter to an electrical outlet after
ensuring it is connected to the device's power
cord.
6