Mains Power Adaptor (Optional) - Petsafe Staywell 500 Série Guide De L'utilisateur

Low battery power
Cat fl ap
When the batteries are starting to run low the cat fl ap will warn you by
emitting a bleep every 2 minutes. The LED will fl ash continually.
Remove the battery cover by pushing in the direction of the arrows.
FIG. 21
Collar key
As the power in the collar key batteries runs low you will notice a loss
of range as your cat approaches the door. Eventually the battery power
will become so low that the cat door will not open and the LED will stop
fl ashing. To restore power, replace the two batteries in the collar key and
refer to "Powering the Infra-red key".
9
Remove the old batteries
and insert 4 x new AA 1.5V
Alkaline Long Life batteries.
(Fig. 21). Replace battery
cover. Your cat fl ap will
need reprogramming.
Follow instructions for
"Programming the Infra-red
cat fl ap".

Mains power adaptor (optional)

A mains power transformer kit can be purchased from the Staywell
website - www.staywell.co.uk. Instructions are provided explaining how
to install. Once installed, place the jack plug into the socket at the side
of the cat fl ap (Fig. 22). Plug adaptor into a household electric socket
(Fig. 23).
FIG. 22
Batteries can be left installed as a back-up power supply. If you are
powering the cat fl ap with the mains power adaptor, and there have been
no batteries installed, you will need to program your cat fl ap. Follow
instructions for "Programming the Infra-red cat fl ap".
FIG. 23