Setting The Air Temperature; Setting The Humidity Level; Food Holding Guide - Hatco Flav-R-Fresh FDWD Série Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Setting the Air Temperature

1. Press the
key (air temperature) to enter temperature
mode ("tSP" will appear on the cabinet temperature
display).
2. Press the
key again to show the current temperature
setting.
3. Press the
key or
temperature. The temperature range is 80°–195°F (27°–
91°C) in single degree increments. See the "Food Holding
Guide" in this section for recommendations.
4. Press the
key to save the setting.
5. After the desired temperature is set, wait 15 seconds
without pushing any keys for the cabinet temperature
display to return automatically to operational mode.

Setting the Humidity Level

Use the following procedure to set the humidity level on
humidified units.
1. Press the
key (humidity) to enter humidity mode
("hSP" will appear on the cabinet temperature display).
2. Press the
key again to show the current humidity
level.
3. Press the
key or
humidity level. Humidity range is 0 through 5 (0 is no
humidity, 1 is the lowest amount of humidity, and 5 is the
highest). See the "Food Holding Guide" in this section for
recommendations.
4. Press the
key to save the setting.
5. After the desired humidity level is set, wait 15 seconds
without pushing any keys for the cabinet temperature
display to return automatically to operational mode.

Food Holding Guide

Type of Food
Biscuits
Chicken Pieces (Fried)
Croissants
Fruit Pies
Onion Rings
Pizza — Thick Crust
Thin Crust
Pretzels
Wrapped Sandwiches
NOTE: All times and settings are recommendations only and may vary depending on product preparation, cooking time, and
internal food temperature.
Form No. FDWDM-1019
key to reach the desired
key to reach the desired
Maximum
Holding Time
4 Hours
4 Hours
4 Hours
3-1/2 Hours
1/2 to 1 Hour
1 Hour
1 Hour
3 Hours
2 Hours
NOTE: Temperature and humidity settings may vary depending
upon product make-up and consistency. The cabinet
temperature display shows the lowest temperature
point inside the cabinet, not the product temperature.
The capacity of the water reservoir permits uninterrupted
operation for approximately 3–6 hours, depending on the
settings and how frequently the door is opened. When "LO H2O"
is flashing on the cabinet temperature display, add water to the
reservoir. The water reservoir refill capacity is approximately 64
ounces, or two (2) quarts (1.9 liters). WARNING! ELECTRIC
SHOCK HAZARD—Do not overfill water reservoir.
Humidity
Setting
4
5
1
4
1
4
5
4
4
11
OPERATION
Control Panel
Temperature
°F
°C
130
55
175
80
140
60
140
60
175
80
185
85
180
82
140
60
180
82

Publicité

Chapitres

Table des Matières
loading

Table des Matières