Using The Product - Ryobi ZTR480ex Traduction Des Instructions Originales

Push the right drive lever farther
forwards than the left drive lever to
perform a forward left turn.
Push the left drive lever farther forwards
than the right drive lever to perform a
forward right turn.
Pull the right drive lever farther back
than the left drive lever to perform a
reverse left turn.
Pull the left drive lever farther back than
the right drive lever to perform a reverse
right turn.
To make a zero turn, slow down, but make
sure that the rear wheels are still in motion.
Then move the drive levers in opposite
directions one past neutral and one before
neutral position. Which lever is in which
position determines the direction of the
turn.
To perform a right zero-turn, slow down,
and simultaneously push the left drive
lever forwards in front of the neutral
position, and pull the right drive lever
backwards behind the neutral position.
To perform a left zero-turn, slow down,
and simultaneously push the right drive
lever forwards in front of the neutral
position, and pull the left drive lever
backwards behind the neutral position.
NOTE:
during the turn (as opposed to completely
stopping) helps prevent damage to the
lawn.

USING THE PRODUCT

See fig. 15 - 16.
WARNING
Clear the area of bystanders before
operating the product. If anyone enters the
mowing area, stop immediately and do not
return to mowing until the bystanders leave
the area.
Before starting the product:
Ensure that the work area is clear of
children, bystanders, and pets.
thrown by the mower blades.
Check the brake operation.
Check the tyre pressure.
Check for loose fasteners.
Make sure that all guards are in place and
working properly.
Clean debris from mower.
Check the side discharge chute safety
interlock system.
Test the operator presence safety interlock
system.
Verify the battery charge level.
WARNING
When the level of battery charge reaches
the red zone on the battery charge
indicator, the blades automatically stop.
Immediately return to the charging location,
and recharge the mower. Continuing to
mow when the battery charge level is in the
red zone causes the mower to be stranded
away from the charging area.
NOTE: If the mower is stranded away from
the charger, set the direction control switch
to the neutral (N) position, and push the
mower back to the charging location.
Mowing:
1. Set the cutting deck to the maximum
height.
2. Insert the start key, and turn the key to the
ON position.
3. Disengage the parking brake.
4. Set the drive levers in the neutral position.
5. Drive to the mowing location.
6. Stop the mower, engage the parking
brake, and turn the start key to the OFF
position.
7. Set the cutting deck to the preferred
position.
8. Turn the start key to the ON position, and
disengage the parking brake.
9. Pull up the blade engage knob to activate
the blades, and mow the lawn.
WARNING
Use caution when crossing over gravelly
paths or driveways. Before crossing, stop
the blades and set the cutting deck to the
maximum height to minimize the possibility
of ricochet. Drive slowly to avoid loss of
traction and control.
EN
FR
DE
DA
SV
FI
NO
English | 25