Required Tools - Ryobi ZTR480ex Traduction Des Instructions Originales

ASSEMBLY SAFETY RULES
WARNING
understand the assembly section of this
manual before attempting to assemble the
product. Save this guide for future reference.
WARNING
Strictly adhere to all torque wrench
All information, illustrations, photographs,
are based on the latest product information
available at the time of publication. Due to
improvements or other changes, there may
be some discrepancies in this manual. We
reserve the right to make product changes at
any time, without notice and without incurring
any obligation to make the same or similar
changes to any products previously built or
sold.
Any person attempting to assemble the
product must have proper training and
experience. Read this manual carefully
and follow all assembly procedures in this
manual.
All assembly must be completed with the
product on a level surface.

REQUIRED TOOLS

The following tools are needed for assembly:
Torque wrench
Tyre pressure gauge
Socket wrench
12 mm socket
13 mm socket
6 mm hex bit
12 | English
UNPACKING
See fig. 1.
Remove the bolts securing the corner and
side braces to the frame bottom, then lift
the braces to remove.
Cut the nylon straps securing the front and
rear wheel axles to the frame.
Remove the boxes containing loose parts,
assembly hardware, and documentation.
Remove and set aside all accessible
packaging and wrap from the unit and
parts. Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the product.
WARNING
If any parts on the "Loose parts list" section
are already assembled to the product
when you unpack it, verify that the part is
assembled correctly, is properly tightened,
and is torqued correctly (where applicable)
before proceeding to the next assembly
step. Use of a product that may have
been improperly assembled could result in
Inspect the product carefully to ensure that
no breakage or damage occurred during
shipping.
If any parts are damaged or missing,
contact an authorised service centre.
NOTE: The product should be assembled
while positioned on the frame bottom.
Once assembly is complete, set the cutting
deck to its maximum height, then position a
ramp next to the frame bottom, and slowly
and carefully drive the product off the
frame.