Makita LS0815F Manuel D'instruction page 12

1
2
001549
Guide fence (SLIDING FENCES) adjustment
014278
CAUTION:
Before operating the tool, make sure that the
•
sliding fence is secured firmly.
Before bevel-cutting, make sure that no part of
•
the tool, contacts the sliding fence. when fully
lowering and raising the handle in any position
and while moving the carriage through its full
range of travel.
010407
CAUTION:
When performing bevel cuts, slide the sliding
•
fence to the left and secure it as shown in the
figure.
This tool is equipped with the sliding fence which should
ordinarily be positioned as shown in the figure.
However, when performing left bevel cuts, set it to the
left position as shown in the figure if the tool head
contacts it.
When bevel-cutting operations are complete, don't
forget to return the sliding fence to the original position
and secure it by firmly tightening the clamping screw.
1. Support
2. Turn base
1. Sliding fence
1
2. Clamping screw
2
1. Sliding fence
1
Vertical vise
1
3
4
5
014289
The vertical vise can be installed on either the left or
right side of the guide fence. Insert the vise rod into the
hole in the guide fence and tighten the screw on the
back of the guide fence to secure the vise rod.
Position the vise arm according to the thickness and shape of
the workpiece and secure the vise arm by tightening the screw.
If the screw to secure the vise arm contacts the guide fence,
install the screw on the opposite side of vise arm. Make sure
that no part of the tool contacts the vise when lowering the
handle fully and pulling or pushing the carriage all the way. If
some part contacts the vise, re-position the vise.
Press the workpiece flat against the guide fence and the
turn base. Position the workpiece at the desired cutting
position and secure it firmly by tightening the vise knob.
WARNING:
The workpiece must be secured firmly against the
•
turn base and guide fence with the vise during all
operations. If the workpiece is not properly secured
against the fence the material may move during the
cutting operation causing possible damage to the
blade, causing the material to be thrown and loss of
control resulting in serious personal injury.
Holders
2
014284
The holders can be installed on either side as a
convenient means of holding workpieces horizontally.
Slip fully the holder rods into the holes in the base. Then
tighten the holders securely with the screws.
WARNING:
Always support a long workpiece so it is level
•
with the top surface of the turn base for an
12
1. Vise arm
2
2. Vise knob
3. Vise rod
4. Screw
5. Guide fence
1. Holder
2. Screw
1