Oven Care; Maintenance Functions - Jenn-Air JJW6024HL Guide D'utilisation Et D'entretien

The Drain, Descale, and Steam Clean functions are under "Settings".
Function
Drain
Descale
Steam Clean
Follow the instructions in the appropriate function section to use the special functions.
Drain
To ensure that no residual water is left behind, the Drain function
can manually drain the boiler. Empty the water tank and return it
to its compartment before using the Drain function.
To Use the Drain Function:
1. Press Settings.
2. Select Drain function.
If the temperature in the boiler is above 140°F (60°C), the
oven will not start the Drain function. Once the temperature
has dropped below 140°F (60°C), it will begin to drain
automatically.
3. The display will show the status of the cycle. "Please remove
and empty container" will appear at the end of the cycle.
4. Empty the water tank and return it to its compartment before
closing the oven door. Press OK when done.
Descale
When oven descale is necessary, "Descale requested" will
appear on the display. When this message appears, descale
must be completed before another oven cycle can be run.
Before beginning the descale function, be sure that you have
enough descaling liquid available. Use a descaler that is suitable
for coffee and espresso machines and kettles.
NOTE: Once the descale cycle has begun, the descaling
procedure must be completed.
To Use the Descale Function:
1. Make sure the oven is empty.
2. Press Settings.
3. Select Descale function.
The oven will prepare for descale.
4. In the water tank, mix 34 oz (1 L) of water with 8.5 oz
(250 mL) of descaler and replace the water tank into its
compartment.
5. Press OK.
6. Follow the on-screen instructions. Do not interrupt the cycle
until it has finished.
7. The display will show a message ("Please remove and empty
container") at the end of the cycle.
8. Empty the water tank and return it to its compartment before
closing the oven door. Press OK when done. No residue
should be present in the system. The oven is properly
descaled and ready to use.
NOTE: When oven descale is recommended, "Descale
requested" will appear on the display. If this appears you
can continue to use the oven without running descale but
after roughly 10 hours of more usage, descaling will be
required.
18

OVEN CARE

Maintenance Functions

Suggested Use
Use to manually drain the boiler.
Use to descale the boiler.
Use to rinse the oven.
Steam Clean
IMPORTANT: Do not use oven cleaners or any other additives
with the Steam Cleaning function.
The Steam Cleaning function is used to soften hard soiled
particles and make cleaning easier. Use the Steam Cleaning
function as soon as possible after spills occur. The longer a spill
sits and dries in the oven, the more difficult it may be to remove.
IMPORTANT: Since the water in the oven bottom is hot, do not
open the oven door during the Steam Cleaning function.
Press CANCEL at any time to end the cycle. The display will
return to the time of day.
To Use the
1. Remove wire shelf and trays from the oven cavity.
2. Close the oven door.
3. Select Settings.
4. Select the Steam Clean function.
5. Follow the on-screen instructions.
6. Press START to begin the cleaning cycle.
Helpful Hints
Once the Steam Cleaning function is complete, remove all
■
remaining water and debris in the bottom of the oven with a
sponge or cloth.
Wipe any remaining moisture from the oven door interior and
■
oven cavity interior sides.
Use a soft brush or nylon scrubber to wipe the oven interior.
■
This may help with more stubborn stains.
If any soil remains, run a second Steam Cleaning cycle to
■
help loosen debris for easier removal.
Use the Steam Cleaning on small spills such as cheese or
■
sauce from pizza or snacks, or drips from casseroles.
Food spills containing sugar, proteins or starches may
■
require vigorous scrubbing to remove most of the debris.
Stea
m Cleaning Function: